Several common faults and solutions of laser coders

Causes of no light: There are several reasons and solutions

1. The optical path screw of the whole machine is loose and needs to be tightened.

2. There is too much dust in the gun body to prevent damage to the gun endoscope. If found, the gun endoscope must be replaced.

3. If the water tank is turned on for a long time and the laser power is not turned on, it may cause problems such as freezing and no light. If such a problem occurs, you need to turn off the power of the whole machine, and restart it after a while.

4. The bulb must be replaced if the bulb is aging or the power of the laser decreases.

5. After working for a long time, the laser power is reduced and the bottom cover of the gun body is opened, which needs to be adjusted in the endoscope of the gun. Trouble 5: Computer FAQ

Computer FAQ: There are several problems

1. Whether the graphics during processing is complex, it must be checked.

2. The computer of the marking machine should not be connected to the Internet, because it is a separate control laser system, and the network will crash due to a virus.

3. The operation is slow, please wait patiently and do not do other illegal operations to avoid computer crash.

4. If an error occurs in the system, please be careful to prevent viruses.

The XY axis of the worktable is not timely

1. The screws of the slide rail of the worktable are loose

2. Set the worktable according to customer requirements The glass on the top, the iron plate or the plexiglass plate can be replaced, and the balance can be adjusted under the glass.

3. The right side and upper and lower corners of the workbench can be equipped with electronic rulers, which can be installed to meet customer needs.

4. The screw holes on the worktable are convenient for customer positioning, which depends on the product.

Bounces during operation and has a roughly fixed position. The following reasons and troubleshooting methods:

1. The synchronous belt is stretched and deformed for too long-----replace with a new synchronous belt.

2. The gear reducer of the large and small gear reducer has dirt-----clean the dirt of the pinion groove.

3. There is dirt on the pinion gear of the drive shaft—clean the dirt on the gear groove of the drive shaft.