The printer is easy to carry and easy to operate, which is your best choice

The coding machine is widely used in the packaging industry. It is a non-contact inkjet marking system controlled by a single-chip microcomputer. It controls the internal gear to supply compressed gas from the outside of the machine to apply a certain pressure to the ink in the system, so that the ink is ejected through a nozzle with an aperture of tens of micrometers, and is printed on different positions on the product surface to form various characters, patterns and other signs required. In order to achieve the best coding effect, the correct use method is essential. Next, I will introduce the use method and advantages and disadvantages of the coding machine for everyone.　　The printer is easy to use, and can be used after the power is turned on after warming up. Consumables are included. Ribbon writing ink rollers have low cost, simple operation, small footprint, and are generally used by small and medium-sized enterprises. How to use the coding machine: 　　 1. Install the ribbon: first remove the movable plexiglass splint of the belt and take-up, put the ribbon into the belt-loading cover, then put on the tightening nut, and then glue the end of the ribbon On the hollow paper tube, put in the take-up device, put on the plexiglass splint, and tighten the nut; 　　2, adjust the width of the ribbon: adjust the plastic retaining ring of the movable guide belt, so that the distance between the two circlips is colorimetric and bandwidth lmm;　　3. Adjusting the resistance of the ribbon feeding: During the printing process of the printer, the ribbon should not be too loose, and should be properly crimped to avoid too much resistance, so as to ensure that the ribbon has sufficient tension after printing, and it will not appear The ribbon sticks to the printed material, or the ribbon is misaligned during operation; 　　4. Adjustment of typing pressure: According to technical requirements, the end face of the print head is lower than the upper end face of the material: about 1.5mm, if it is too low, it will If the pressure is too high, it is easy to break the ribbon, or the handwriting is too thick; on the contrary, if the force is too low, there will be an abnormal phenomenon of unclear handwriting; 　　 5. Stroke adjustment method: first loosen the screw cap on the hexagonal side rod Turn it on, then adjust the hexagonal side bar and rotate it to the left. The print head will rise and go down to the right. One rotation is about 0.4mm, and one rotation (six corners) is equivalent to 2.5mm.　　6. u200bu200bRibbon feed stroke adjustment; To change the distance of the ribbon feed stroke, adjust the position under the stroke screw to change the length of the tape feed. The distance between the character lines is preferably 1mm.