The correct way to clean and maintain S60 inkjet printer

If the printer is stopped for a long time without ink discharge, it should be turned on once a week (ink supply), and cycle for more than 2 hours each time. 1. Check and clean the print head. The machine has been running for a long time. If the high-pressure board of the print head or other places has ink or other burrs, the machine may not be able to type properly. At this time, the nozzle is routinely cleaned to remove burrs, etc., and the machine will maintain a good operating condition. Therefore, the nozzle must be cleaned after daily use. After washing, use a non-woven cloth to dry or dry directly. Be careful not to use a lint-free paper towel or cloth to dry. 1. Clean the main unit, casing, fan filter The main unit and casing can be wiped with anhydrous alcohol to remove ink and stains on them. Remove the fan filter and wash it with clean water, dry it, and put it back in place. 2. Replace the ink filter. Replace the main filter: clean the spare filter with solvent, unscrew the filter connector, and connect the new filter in the original position. The outlet of the pump is connected to the inlet of the main filter. (The inlet is on the edge of the filter) Replace the small filter: clean the spare filter with solvent, unscrew the filter connector, and connect the new filter in place. 3. Replace the ink. The ink cycle time period is 300 hours. If the printing speed is fast and new ink is constantly being replenished into the machine, the ink can be used continuously. If the printing speed is slow, and there is no new ink replenishing the machine after 150 hours of ink circulation, the old ink should be discharged after 300 hours and replaced with new ink. The way to replace the new ink: discharge the ink from the ink outlet at the bottom of the ink tank. 2. Long-term downtime for maintenance If you have been down for a long time for more than half a year, all ink should be discharged, and the ink should be replaced with solvent to run (manually test the pump switch, ink supply valve, and recovery valve during factory commissioning) until the pipeline is cleaned.